KX Guru Racing

Posted: **Mon Oct 10, 2016 3:15 am**

Very nice... Tell Tommy Roberts I appreciate his help....

So many have come together outside of our team to help it is really amazing.
I thank you all....

Posted: **Mon Oct 10, 2016 3:25 am**

Alex Ward has been a huge help on the suspension and the two piece clutch cover.
Here is a short vid of him dumping the oil from Sean's Enzo built shock

https://www.voxer.com/v/e142e72f2d

Posted: **Tue Oct 11, 2016 2:34 am**

After lapping we installed the alignment pins and mated the cases together.

: KX GURU RACING SEAN COLLIER KX500 204.JPG (190.41 KiB) Viewed 8967 times

Jason is holding the cases up to some light so he can check the cases for any air gaps... NONE

: KX GURU RACING SEAN COLLIER KX500 205.JPG (82.26 KiB) Viewed 8967 times

Since the deck was off from one case to another about .001" I went ahead and made sure they were the same height..
After cleaning these cases up again we will finally be ready for assembly.

: KX GURU RACING SEAN COLLIER KX500 206.JPG (178.79 KiB) Viewed 8967 times

Posted: **Wed Oct 12, 2016 3:00 am**

Spent a bit of time cleaning and polishing..
Yeah, there's a bit of wear on these but they will work just fine for a while longer.

: KX GURU RACING SEAN COLLIER KX500 207.JPG (153.16 KiB) Viewed 8963 times

Now that we got all the crud out of here I'm sure the Kips will rattle pretty good

: KX GURU RACING SEAN COLLIER KX500 208.JPG (68.53 KiB) Viewed 8963 times

: KX GURU RACING SEAN COLLIER KX500 209.JPG (146.21 KiB) Viewed 8963 times

Posted: **Wed Oct 12, 2016 3:01 am**

Into the oven... New bearings and seals installed..

: KX GURU RACING SEAN COLLIER KX500 210.JPG (171.93 KiB) Viewed 8962 times

More polishing...

: KX GURU RACING SEAN COLLIER KX500 211.JPG (496.13 KiB) Viewed 8962 times

Posted: **Wed Oct 12, 2016 3:03 am**

More and more polishing....

: KX GURU RACING SEAN COLLIER KX500 212.JPG (77.33 KiB) Viewed 8961 times

I was going to give the reed a quick clean up but then decided to go all out and disassemble it.
It's a good thing I did because I found a crack in it..

: KX GURU RACING SEAN COLLIER KX500 213.JPG (83.12 KiB) Viewed 8961 times

Posted: **Wed Oct 12, 2016 3:06 am**

I had to run into town late this afternoon as the cases were heating up.
When I got back Jason was locking up.
I had to sneak in and see what he got finished..