Worn out clutch arm puller replacement/fix?

[Burle]

I have a couple clutch arm pullers (RELEASE-COMP-CLUTCH Part# 13102-1107) that are pretty worn out.

20200508_214951_resized.jpg (195.29 KiB) Viewed 5641 times

20200508_214737_resized.jpg (156.32 KiB) Viewed 5641 times

20200508_214653_resized.jpg (268.91 KiB) Viewed 5641 times

20200508_214750_resized.jpg (157.37 KiB) Viewed 5641 times

20200508_214826_resized.jpg (143.61 KiB) Viewed 5641 times

Discontinued part, does anybody have a way to repair these? Is there maybe one from a different bike that will work?

Thanks

[Sandblaster]

Wow! Those are bad...
Did you check eBay?

[Burle]

Yeah I really don't know how they get that bad, I got both these engines 20th hand.

EBay's got nothing

I might be able to use one from a '99 KX250, general dimensions look similar. I checked and the needle bearings they both rotate on are the same so they've gotta be the same diameter

This is the discontinued part

MzIxODE0-5bb56c21.jpg (56.13 KiB) Viewed 5627 times

And here is a '99 KX250 arm

MzI1ODY2-834207a6.jpg (52.47 KiB) Viewed 5627 times

In the picture it looks like the flat spot might be cut a little deeper on the 250 one

Even if it is cut a little deeper I may be able to just add a spacer to the opposite end of the clutch push rod to make up for that.

[Sandblaster]

Yeah, they are discontinued.
The shaft size on the 250 are the same.
I am not sure about the length of the arms.