2016 KTM 300 MEGA ENGINE AND BIKE BUILD :o

[Sandblaster]

The question came up as to how many CC's am I adding to the lower end crankcase volume by modding the crankcases.
Approximately 22.23 cc per case half.
Or, Approximately 44.46 cc of lower crankcase volume.
I will need to calculate the amount removed from the crankshaft as well but it is not much

Will this change the engine performance?
We will see...

[Sandblaster]

Here is some before pics of the bike..

84118055_793935034419596_3424010806692413440_n.jpg (212.14 KiB) Viewed 7479 times

84332142_187049649220193_1218286637654474752_n.jpg (159.86 KiB) Viewed 7479 times

86225140_186560099376247_6018739960549474304_n.jpg (90.29 KiB) Viewed 7479 times

[Sandblaster]

86236499_2774599685966185_3202967003383988224_n.jpg (139.83 KiB) Viewed 7478 times

86288184_188825242229667_1078897661655908352_n.jpg (169.89 KiB) Viewed 7478 times

86350495_189942875444227_2654867320295391232_n.jpg (135.53 KiB) Viewed 7478 times

[Sandblaster]

Ok... The owner has started engine asy...

[Sandblaster]

More progress.

29687.jpeg (55.44 KiB) Viewed 7109 times

29691.jpeg (66.86 KiB) Viewed 7109 times

29693.jpeg (64.11 KiB) Viewed 7109 times

29706.jpeg (126.39 KiB) Viewed 7109 times

29708.jpeg (136.66 KiB) Viewed 7109 times

[Sandblaster]

The engine was assembled with a .024" base gasket or .6mm.
We used the stock head and ran it.
Cylinder pressure was 175psi.
The results?
We lost 3 HP at the rear wheel

Where it improved is the over rev..

But, that was not unexpected...
Next we are going to start lowering the Port timing and see what happens.
If it reacts as the KX500 did then we should see some real improvements.

So stay tuned!!

resize.jpg (659.59 KiB) Viewed 7038 times

[Sandblaster]

Ok...
This build is still under way.
Rider feedback from Novice to Pro level riders is this is a awesome bike.
The power is smooth and controllable.
The handling is superb when compared to a 450 as it weighs about 30 lbs less yet the engine has approx the same HP and torque.
I'll get some dyno pulls posted before long...

20210118_142752_resized.jpg (835.43 KiB) Viewed 5879 times

20210118_142816_resized.jpg (796.46 KiB) Viewed 5879 times